
SWITCH ACTUATOR SERIES
PRODUCT DESCRIPTION – SWITCH ACTUATOR SERIES
KA/R0816.1 KA/R0416.1 KA/R1216.1
The switch actuators are the modular installation devices, with 4, 8 and 12 outputs to choose from, using EIB BUS connection terminals to connect to the system. The switch actuators are connected to the AC power supply directly instead of an extra voltage supply. It is able to use the Engineering Tool Software ETS (ETS2 v1.3 or later) with a VD2/VD3 file to allocate the physical address and set the parameters. It is able to switch from 4 to 12 independent electrical AC loads or three-phase loads by the switch actuators with maximum output of 16A per output and manual switch, as well as visible switching status.
Power Supply: 21~30V DC, bus powered
Current: <12mA
Power comsuption: Max. 360mW
Installation: on 35 mm DIN rail
Temperature Range: Operation -5℃ ~ 45℃ Storage -25℃ ~ 55℃ Transport -25℃ ~70 ℃
Outputs: 4ch/8ch/12ch
Rated Voltage Current: 250 VAC (50/60 Hz) 16A
Operating/Display: Red LED and push button for assigning the physical address; flashing green LED means the device is working normally
Dimmension: 4ch switch actuator 71,5 x 90 x 60 mm, 8ch switch actuator 143 x 90 x 60 mm, 12ch switch actuator 214,5 x 90 x 60 mm
FUNCTIONS:
> manual operation available.
> time functions, on/off delay.
> scene control/presets via 8 bit/1 bit commands.
> logic operation AND, OR, XOR, gate function.
> status response.
> forced operation and safety function.
> reaction to threshold function.
> control of electro thermal valve drives. > selection of preferred state after bus voltage failure and bus recovery.
> staircase lighting functions with warning and adaptable staircase lighting time